An all-in-one radio replacement and SWC interface, the innovative RadioPRO4 comes pre-loaded with amplifier retention and SWC software, navigation-based output signals, and other features that save time and money during installation.
Retains OEM steering wheel control functions (pre-programmed)
Data controlled 10 amp accessory output
Removes SOS error light from cluster after factory radio is removed
Data controlled outputs for connecting an aftermarket navigation radio
Single programmable 12V output
Easily configurable using a PC application
Highly visible tricolor LEDs to keep the user informed of the module’s status
Retains factory amplifier (Non-Fiber Optic)
Retains i-Drive control. Operates some features of the aftermarket radio (tuning, etc.)
Retains warning chimes (including rear park assist and front collision detection)
Direct USB updatable. PAC-UP NOT Required
Patent # 8,014,540 & 8,184,825
Application Guide
Year(s)
Make
Model
Trim Level
Additional Info
2009, 2011-2014
BMW
1 SERIES
ALL TRIM LEVELS
—
2006-2015
BMW
3 SERIES
ALL TRIM LEVELS
—
2010-2014
BMW
5 SERIES
ALL TRIM LEVELS
—
2011-2014
BMW
6 SERIES
ALL TRIM LEVELS
—
2006-2015
BMW
M3
ALL TRIM LEVELS
—
2010-2014
BMW
M5
ALL TRIM LEVELS
—
Compatibility Notes
Incompatible with vehicles equipped with the upper display screen (above radio) (CCC or CIC systems). This screen is not retained if the radio is removed, and the owner will lose the ability to adjust some vehicle settings. Radio replacement is not recommended for those applications.
Does not retain amplifiers equipped with a Fiber-Optic input
1 Series equipped with navigation is not compatible
2006 3 Series coupe is not compatible
Due to lack of a true 12 volt battery lead at the radio opening, it is necessary to run a wire (wire is included) to the battery (located in the trunk).
