Features C.L.E.A.N. Set-up with 10-step set-up procedure w/ input/output clip detection and indicator LEDs
Pulse Width Modulated MOSFET power supply
LED power (blue) and protect (red) indicators
Stealth top mounted control panel
Soft start turn-on
4, 3 or 2 channel operation
Nickel-plated RCA level inputs
Nickel-plated captive C-clamp terminals
High level input capable with Auto Turn-On circuit (RFIF2SW required, sold separately. Up to TWO adapters needed for this amplifier.)
3-way protection circuitry (thermal, overload, and speaker short protection)
On-board differential inputs eliminates noise picked up by the signal cable
Integrated Trans•ana technology simplifies the signal path of the amplifier allowing the signal to travel through the amplifier at a lower voltage. The result is greater reliability and exceptional sound quality
MESHA3 reduces MOSFET temperatures, lowers distortion, increases durability, and prolongs the output device life span
DSM (Discrete Surface Mounted Components) utilize 1% tight-tolerances improving efficiency of the circuit and lowers operating temperature and potential for noise - similar to circuit boards designed by aerospace manufacturers
Built in NOMAD is a "real time" analog computer that protects your amplifier from shorting speaker wires and dangerously low speaker impedances
Cast aluminum convection heatsink with DTM (Dynamic Thermal Management) evenly distributes excess heat across entire amplifier heatsink to efficiently keep the amplifier temperatures low
50 Watts x 4 @ 4-Ohm , 100 Watts x 4 @ 2-Ohm , 200 Watts x 2 @ 4-Ohm Bridged
Dynamic Power
82 Watts x 4 @ 4-Ohm , 137 Watts x 4 @ 2-Ohm , 266 Watts x 2 @ 4-Ohm Bridged
Bridgeable
Yes
Frequency Response (Hz)
20Hz to 20kHz +/- 1.0dB
Input Sensitivity High
150 mV - 12 V
Circuit Topology Class
Class A/B
Efficiency (average)
67% @ 4-Ohm
Total Harmonic Distortion (THD+Noise)
4-Ohm: <1.0%, 2-Ohm: <1.0%
Signal Input
Hi/Low level: 2 RCA pair
Tone Controls
Front Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or Front Punch EQ2 Treble: 0dB to +12dB @ 12.5kHz Rear Punch EQ2 Bass: 0dB to +18dB @ 45Hz and/or Rear Punch EQ2 Treble: 0dB to +12dB @ 12.5kHz Function depends upon LP/AP/HP switch position
Visual Indicators
Power/Protect/Thermal LED Input Clip LED3 Output Clip LED1,2,3 LED Color Legend: 1BLUE: <0.5% THD 2VIOLET: 1% THD 3RED: 10%+ THD
